MindStudy, question and answer site designed to help students, to help each other:
To ask, to learn, to share, to grow.
Get the right answers. Fast
Submit answers for community.
Pat yourself on the back. You deserve it.
542 questions
What is the definition of a overhanging beam?
An overhanging beam is a beam that extends beyond its support at one or both ends. Unlike a regular beam that's fully supported, an overhanging beam has parts that stick out past where it’s held up.
What is the compression and tension zone of a cantilever beam and what are the significant of this?
The primary areas of a cantilever beam that bend when a load is applied are the compression and tension zones: The compression zone is located in the lower portion of the beam.
What is flange beam?
A flange beam is a type of beam that has wide extensions, called flanges, at the top and bottom. These flanges help the beam handle bending and shear forces much better.
What is strriup ?What is the function of strriup?
A stirrup is a piece of steel reinforcement used in concrete beams and columns. It's usually shaped like a closed loop and wraps around the main vertical rebar.
What is the minimum specing of strriup according IS456:2000?
According to IS 456:2000, the Indian Standard for plain and reinforced concrete, the minimum spacing for stirrups in beams is specified as follows:
What is Bent up bar in Beam?
A bent-up bar in a beam is a type of reinforcement bar (rebar) that is angled or bent upwards at a specific point along the length of the beam.
For a broadcast super heterodyne AM receiver having no RF amplifier, the loaded quality factor Q of the antenna coupling circuit is 100. Now if the intermediate frequency is 455 KHz, then determine the image frequency and its rejection ratio at an incoming frequency of 1 MHz.
Given that quality factor Q = 100 The intermediate frequency fi = 455KHz
Write short notes on:
The second method of the non-coherent AM detection is Envelope Detector. In this circuit modulated signal Vin(t) is used as an input signal. The source resistance RS is connected in series with the active non-linear p-n junction diode.
What are cross field device? What role does the dc magnetic field play in their normal operation?
The cavity magnetron is a cross field device. Here the electric field between anode and cathode is radial whereas the magnetic field produced by a permanent magnet is axial.
What do you mean by cut off frequency of a waveguide? On what factor does the cut off frequency of a waveguide depend? Derive expression in support it.
Several modes of electromagnetic waves, corresponding to the solution of the Maxwell’s equations, propagate inside a waveguide. A given waveguide has a definite cut-off frequency for each allowed mode.
MindStudy - a preparation hub for all the students. The goal is to make it easier for pupils to get better grades on exams.
Copyright © 2025 MindStudy
A product by Shunya Intelliware Solution
(Registered under MSME Uddyam)